Gauge Pod Options?

[Glass Joe]

What are you all doing for gauges? Currently Im setup with an A/F, Boost, and Oil Pressure gauges in my A-pillar and they are larger than Id like. Are there other places people are putting gauges on the SVTs, or is the A-pillar the only real option?

If it is the best option, what brand pod should I be looking at? My current one is junk.

Also, how important is it that I know my A/F ration on a JRSC Big Boost Kit application that is being daily driven? Sure I get on it once in a while, but its been professionally tuned (conservative) and Im never throttling it for long periods of time. Id understand having the gauge is a good idea, but perhaps putting it somewhere a little bit less 'distracting' than on the A-pillar perhaps? Ideas?

Thanks.

[Patalrob]

I don't have a gauge setup in my car yet but I have a A-piller 3-pod that I will be useing.

You could use your two center air vents to put gauges in, I have seen that done.

A/F is probably the most important gauge. Sure the chances of anything happening are slim but its there to let you know if something is not right.

These are about your only choice's for A-piller pods
http://focus.c-f-m.com/index.asp?PageAc ... tegory=313

[Redlineracer12]

Is it a real wideband o2 sensor?

[Glass Joe]

Yes, I believe so. It was on the car when I bought it and everything was installed at Massive, and the gal I bought it from was pretty hardcore.

I dont know much about FI or the gauges that go along with it, but this thing is bouncing around its arc all of the time. It usually hovers at the 1:00 position, displaying 15.5 to 16. Under throttle, it decreases to 11 or so, but quickly resumes its position back in the 15.5-16 range while cruising.

This is the gauge:
http://www.innovatemotorsports.com/products/xd16.php

[Redlineracer12]

Cool, I'd keep the o2 gauge then. Actually, the whole setup sounds pretty good for a SC'ed car.

[Glass Joe]

I plan on keeping them all, but would like to move them do a different location.

My current gauge pod is junk and Im looking for options.

Thanks.

[focinite]

I dont know much about FI or the gauges that go along with it, but this thing is bouncing around its arc all of the time. It usually hovers at the 1:00 position, displaying 15.5 to 16. Under throttle, it decreases to 11 or so, but quickly resumes its position back in the 15.5-16 range while cruising.

This is the gauge:
http://www.innovatemotorsports.com/products/xd16.php

under WOT you want it rich, especialy with boost, the a/f mix will lean out when the throttle is slapped shut due to the sudden lack of incoming air( the tps and maf will know when the time to shut down the duty cycle of the injectors to lean out the fuel). your set up is doing what its sposta. stoich is like 14.7-1 but this is amaz-a-zingly umpossible to stay at as the demands are a constaint variable . the a/f gauge reads just the same as a os sensor. a o2 sensor will bounce from lean to rich and the cat monitor(o2 sensor 2) will monitor the upstream sensor and calculate in the pcm as how to adjust the fuel trims, thously giving a rich/lean sweep if the tuning is done right( witch it sounds as it is) the o2s and yer and short term fuel trims should corispond with one another to kepp the trims in a constant dance of rich/lean till the womp pedal is pressed into the carpet then the trims will run to one side of the boat and go rich.

[CleanZX3]

I dont know much about FI or the gauges that go along with it, but this thing is bouncing around its arc all of the time. It usually hovers at the 1:00 position, displaying 15.5 to 16. Under throttle, it decreases to 11 or so, but quickly resumes its position back in the 15.5-16 range while cruising.

This is the gauge:
http://www.innovatemotorsports.com/products/xd16.php

under WOT you want it rich, especialy with boost, the a/f mix will lean out when the throttle is slapped shut due to the sudden lack of incoming air( the tps and maf will know when the time to shut down the duty cycle of the injectors to lean out the fuel). your set up is doing what its sposta. stoich is like 14.7-1 but this is amaz-a-zingly umpossible to stay at as the demands are a constaint variable . the a/f gauge reads just the same as a os sensor. a o2 sensor will bounce from lean to rich and the cat monitor(o2 sensor 2) will monitor the upstream sensor and calculate in the pcm as how to adjust the fuel trims, thously giving a rich/lean sweep if the tuning is done right( witch it sounds as it is) the o2s and yer and short term fuel trims should corispond with one another to kepp the trims in a constant dance of rich/lean till the womp pedal is pressed into the carpet then the trims will run to one side of the boat and go rich.

Sweet. So where is he going to put his gauges?

[CleanZX3]

You could hide your radio elsewhere? ha.

https://ssl.perfora.net/www.massivespee ... 79581%3D29

[Patalrob]

You could hide your radio elsewhere? ha.

https://ssl.perfora.net/www.massivespee ... 79581%3D29

I like that

[Glass Joe]

words

So, looking at my gauge (via the link) when that thing swings to the left (12:00 back to 9:00) am I then running rich or lean? Ive assumed that Ive been running lean at that time, but based off of what you just said, it would be rich (since Im at WOT).

As for the radio gauge option ... Im looking for more of a 'stock' appearance. I did find these and thought it was a pretty neat idea. Id have to open my cover up and see how/what my moonroof motor looks like to see if I have room.
http://www.focusfest.com/forum/showthre ... 062&page=3

Thanks for all of the replies thus far.

[Patalrob]

There's not a whole lot of room behind the cover for the moonroof.

Could use this and put it up onto the moonroof cover. It would somewhat hidden.

http://www.festivegarage.com/double-gau ... p-986.html

[Glass Joe]

There's not a whole lot of room behind the cover for the moonroof.

Could use this and put it up onto the moonroof cover. It would somewhat hidden.

http://www.festivegarage.com/double-gau ... p-986.html

Quality idea, thanks.

[focinite]

a good spot to mount a gauge and have it outta site is in the drivers cup holder. other wise take the panal that holds the head light switch and mount it in there.

[Stilz]

You could hide your radio elsewhere? ha.

https://ssl.perfora.net/www.massivespee ... 79581%3D29

I was gonna make one, but I'M SO SOLD!!!