Minnesota Focus Owners Club

Has anybody installed a wet nitrous kit into their zetec focus? Where did you connect the fuel line?

bump

You need a mcnews or other brand fuel rail adapter. It replaces the end cap on the right side of the fuel rail. Hope your engine doesn't eat itself like mine did when I ran that stuff.

I plan on running a 50 shot, what shot did you use?
Are you going to be at the meet on the 24th.

65...

Also you will want colder plugs (AZFS22C), so call Steve and get those also.

so you did 65 on a svt? Was there anything wrong with your set up I should know about?

He has a Zetec.

And the one thing to know is he blew the hell outta the motor. So probably tread lightly with the juice.

ouch, now im nervous. Was it tuned?

yeah, but from what i remember it melted the ground straps off plug alot and, had an issue with keeping the motor bits in the motor.

focinite wrote:yeah, but from what i remember it melted the ground straps off plug alot and, had an issue with keeping the motor bits in the motor.

Should've used more duct tape....

well his problem was it was a zetec...id run a 50 shot on a SVT motor without worrying about it

I still blame the combination of things for the death of that motor. Aggressive cams + nitrous + lack of a proper tune.

I hear the car was fast as hell though with that setup.

I was planning to do a 50 shot on a zetec untuned, not a svt.

I ran a 75 shot a ton of times un-tuned with 100 octane. If i were running n20 again I would get this: http://www.jandssafeguard.com/

From what I understand Pappys was an untuned dry kit.

nuff said.