focus central

Y2k · Fri Jun 29, 2007 8:28 am

Its been ages that I visited focus-central.net (IIRC) did they run out of business or what? I need to get hold of them about the TB Issue i have.

Fri Jun 29, 2007 9:00 am

yeah, FC went out a long time ago. been out for around 2 years i think.

Fri Jun 29, 2007 9:06 am

pretty sure they are gone.

if you give me say $20 i'll help you trouble shoot it on line here.

Fri Jun 29, 2007 9:31 am

Y2k wrote:Its been ages that I visited focus-central.net (IIRC) did they run out of business or what? I need to get hold of them about the TB Issue i have.

Which throttle body, Is yours an SVT or standard Zetec?

umdivx · Fri Jun 29, 2007 9:50 am

the same parent company is still around, but now they just focus on building parts for the Mazda3

- Josh

Y2k · Fri Jun 29, 2007 11:15 am

I have the 65mm zetec TB. i brought this up before but I think I know what the problem is. basically the issue is my RPM can shoots up on random basis or idles at 2.5K because the TB plate didnt close tight enough. to me it seems like the plate is rubbing against the TB wall because everytime i starts up I have to tap the pedal first before i can get going so I THINK it might need some sanding to smoothen the edge abit.

Fri Jun 29, 2007 11:56 am

Y2k wrote:I have the 65mm zetec TB. i brought this up before but I think I know what the problem is. basically the issue is my RPM can shoots up on random basis or idles at 2.5K because the TB plate didnt close tight enough. to me it seems like the plate is rubbing against the TB wall because everytime i starts up I have to tap the pedal first before i can get going so I THINK it might need some sanding to smoothen the edge abit.

Don't sand the plate, There should be an adjustment screw for the throttle stop. Just turn the screw a bit so the plate stops a bit sooner.

If theres no screw you can use a bit of tape or rubber hose to "adjust" the throttle stop.

Y2k · Fri Jun 29, 2007 12:41 pm

I've tweaked around with the throttle stop and that didn't help or it could be me thats not adjusting it right enough.I can try it again later since I already took it apart and replace it with another same kind TB and the replacement works flawlessly.