35?
You sally! Go big or go home ... I want a 125+ shot on my car (because it'll take me that much to FK with Vettes).
Attn: Pat
-
- Posts: 630
- Joined: Wed Mar 24, 2010 10:31 pm
- Car: 2003 Black SVT focus
- Location: woodbury
im just tryin to have a lil fun 125+ sounds like engine go kaboooomm
#722 of 6,158. Stage 3 clutch, aluminum flywheel, MSD coil and wires, C.F.M. offroad pipe, front and rear FSwerks stress bars, Mach HIDs, C.F.M. short shift/w svt knob, Volant intake
-
- have you seen my boxers?
- Posts: 4072
- Joined: Tue Jun 21, 2005 12:11 pm
- Car: 09 Mustang GT, 14 Focus
- Location: WI
I ran a 65 shot for a few years on my zetec.... It hauled ass....
Until the motor ate itself. haha
But that was untuned.
I'd say you'd be fine running a properly moderate 65-75 wet shot (one step colder plugs, bottle heater, pressure gauge, window switch, purge, TUNE). You should have next to no problems.
Until the motor ate itself. haha
But that was untuned.
I'd say you'd be fine running a properly moderate 65-75 wet shot (one step colder plugs, bottle heater, pressure gauge, window switch, purge, TUNE). You should have next to no problems.
Prestige WorldWide The First Word In Entertainment
______________Boats and Ho's!_____________
______________Boats and Ho's!_____________
- Redlineracer12
- I is speshul
- Posts: 3305
- Joined: Tue May 02, 2006 7:36 am
- Car: 00 Contour SVT
- Location: IGH
- Contact:
And have a crap-ton of funPappy wrote:I'd say you'd be fine running a properly moderate 65-75 wet shot (one step colder plugs, bottle heater, pressure gauge, window switch, purge, TUNE). You should have next to no problems.
3 Fords, 1 Mercury, 1 Honda, 1 Yamaha
-
- have you seen my boxers?
- Posts: 4072
- Joined: Tue Jun 21, 2005 12:11 pm
- Car: 09 Mustang GT, 14 Focus
- Location: WI
I honestly loved spray.... It's just awesome the instant hit it gives vs the build up of boost....
Prestige WorldWide The First Word In Entertainment
______________Boats and Ho's!_____________
______________Boats and Ho's!_____________
Much like an iceberg, there's more under the crown than meets the eye.
... and there was Aluminum chunks in the oil pickup. Fortunately all the bearings/bearing surfaces look pristine / haven't pulled the oil pump apart though and don't intend to. The bore on #4, well I'm not sure if it'll clean up or not. Have to find out once I get new pistons/rods (Eagle and JE 11.5:1's).
--John