Zex Wet Shot Nitrous Kit
-
- Posts: 336
- Joined: Tue Jan 19, 2010 3:43 pm
- Location: Coon Rapids
Has anybody installed a wet nitrous kit into their zetec focus? Where did you connect the fuel line?
-
- have you seen my boxers?
- Posts: 4072
- Joined: Tue Jun 21, 2005 12:11 pm
- Car: 09 Mustang GT, 14 Focus
- Location: WI
You need a mcnews or other brand fuel rail adapter. It replaces the end cap on the right side of the fuel rail. Hope your engine doesn't eat itself like mine did when I ran that stuff.
Prestige WorldWide The First Word In Entertainment
______________Boats and Ho's!_____________
______________Boats and Ho's!_____________
-
- Posts: 336
- Joined: Tue Jan 19, 2010 3:43 pm
- Location: Coon Rapids
I plan on running a 50 shot, what shot did you use?
Are you going to be at the meet on the 24th.
Are you going to be at the meet on the 24th.
-
- Posts: 336
- Joined: Tue Jan 19, 2010 3:43 pm
- Location: Coon Rapids
so you did 65 on a svt? Was there anything wrong with your set up I should know about?
-
- Posts: 336
- Joined: Tue Jan 19, 2010 3:43 pm
- Location: Coon Rapids
ouch, now im nervous. Was it tuned?
Should've used more duct tape....focinite wrote:yeah, but from what i remember it melted the ground straps off plug alot and, had an issue with keeping the motor bits in the motor.
2008 Bone Stock VW GLI
2004 Sonic Blue SVT ZX3, #1593 of 1978 Born 4/8/04
Stage 2 ported TB, Semi-custom Borla center exit, FSWerks CAI, FS front strut bar, suspension by FR/Multimatic gone, but not forgotten
2004 Sonic Blue SVT ZX3, #1593 of 1978 Born 4/8/04
Stage 2 ported TB, Semi-custom Borla center exit, FSWerks CAI, FS front strut bar, suspension by FR/Multimatic gone, but not forgotten
-
- Posts: 630
- Joined: Wed Mar 24, 2010 10:31 pm
- Car: 2003 Black SVT focus
- Location: woodbury
well his problem was it was a zetec...id run a 50 shot on a SVT motor without worrying about it
#722 of 6,158. Stage 3 clutch, aluminum flywheel, MSD coil and wires, C.F.M. offroad pipe, front and rear FSwerks stress bars, Mach HIDs, C.F.M. short shift/w svt knob, Volant intake
-
- Posts: 336
- Joined: Tue Jan 19, 2010 3:43 pm
- Location: Coon Rapids
I was planning to do a 50 shot on a zetec untuned, not a svt.
I ran a 75 shot a ton of times un-tuned with 100 octane. If i were running n20 again I would get this: http://www.jandssafeguard.com/
07 ST S.A.P.
- Steve@Tasca
- Midget
- Posts: 8928
- Joined: Fri Jan 21, 2005 1:26 pm
From what I understand Pappys was an untuned dry kit.
nuff said.
nuff said.
Tasca Auto Group- Employee pricing on all parts.
http://www.tascaparts.com/partlocator/i ... eid=213668
1-800-598-1484 or spowell@tasca.com
http://www.tascaparts.com/partlocator/i ... eid=213668
1-800-598-1484 or spowell@tasca.com