Minnesota Focus Owners Club

I have a SVT header wraped with DEI heat wrap with a little over a 1,000 miles.

I ground off the heat sheild tabs to give it a cleaner look.

Looking for $175 *SOLD*





SVT Grill $40



I also have the old header and cat.

They were welded together. I believe because of the header flange catching on the road a ripping it off the Cat side flange is fine. Header side does not have a flange.

Looking for $40 together. *Flex not included*

I'd have to wait for my military pay, but I'd definitly take the wraped header.

Stilz wrote:I'd have to wait for my military pay, but I'd definitly take the wraped header.

Nice

I can hold onto it for you.

You might get more than $40 by recycling the cat....or hang on to it until some of the factory ones fail on the SVTs...replacment from Steve is around $1500, if I remember reading that correctly.

Cat isnt worth nothing if you recycle it. Has stainless not platnium inside

tgnorman wrote:You might get more than $40 by recycling the cat....or hang on to it until some of the factory ones fail on the SVTs...replacment from Steve is around $1500, if I remember reading that correctly.

Thanks for the heads up.

I just sold my old SVT cat to Al for $45. He was saying he found a lot of them being sold AND SELLING for over $100 each.

Also, if you're changing it from a feeler to a sell post... Bring it to the meet ill buy it then. (The wraped header)

Stilz wrote:Also, if you're changing it from a feeler to a sell post... Bring it to the meet ill buy it then. (The wraped header)

Sounds good