Minnesota Focus Owners Club

I'm selling some of my stuff.

FR Zetec head, new. $795 local only. If using paypal, add the 3% fee. sold
Crower Zetec Stage 1 cams, new $225 local only. Add 3% fee for paypal.

I was going to use this combination for a streetable boost 6-8psi turbo set up.

I may or may not sell the remaining bare essentials of the kit:
38lb Precision injectors used lightly, very clean...look new.
Focus RS turbo manifold with heat shield. Used. One bolt for the heat shield snapped off. Not needed, but that's up to you. Both items in good condition. New bolts and gasket for manifold to head.
Garrett T-25 7 psi internal wastegate with downpipe...both new. I have not yet purchased the flange gaskets, bolts, nuts, or oil/water lines.
If someone is interested in the partial turbo kit, shoot me a pm.

I also have:
1. a new black fc 65mm tb Gen 1 w/gasket for 2000-2002.5 Zetec
2. Used black/black deamon/livewire set
3. Brand new, never used, utra rare SVT forged rods with pistons, rings, and bearings installed.

There may be more to come.

what type of mods do you need to run stage one cams??

Pepsi50195 wrote:what type of mods do you need to run stage one cams??

Intake and exhaust.

will the demon livewires set work for the svtf?? and how much u want for it?

mars wrote:will the demon livewires set work for the svtf?? and how much u want for it?

Yes. $65. One of the post clips on one of the wires is missing one half of the clip. The other side is there and clips on just fine.

HotRodWagon wrote:

mars wrote:will the demon livewires set work for the svtf?? and how much u want for it?

Yes. $65. One of the post clips on one of the wires is missing one half of the clip. The other side is there and clips on just fine.

just wondering, that's the Screamin demon coil pack and wires right? and the one wit the 1/2 clip wont move around once installed??

mars wrote:

HotRodWagon wrote:

mars wrote:will the demon livewires set work for the svtf?? and how much u want for it?

Yes. $65. One of the post clips on one of the wires is missing one half of the clip. The other side is there and clips on just fine.

just wondering, that's the Screamin demon coil pack and wires right? and the one wit the 1/2 clip wont move around once installed??

yes, Sreamin Demon coil and black LiveWires. It fits like a normal wire without the clip...snug, but also has the clip. I do not believe the wire will move at all.

HotRodWagon wrote:

Pepsi50195 wrote:what type of mods do you need to run stage one cams??

Intake and exhaust.

like a short ram intake or a whole new mani? i have the exhaust covered....

Pepsi50195 wrote:

HotRodWagon wrote:

Pepsi50195 wrote:what type of mods do you need to run stage one cams??

Intake and exhaust.

like a short ram intake or a whole new mani? i have the exhaust covered....

Not the intake manifold. Just an air intake. You may want to add cam gears to your list. If you plan on tuning the cams any.

how difficult are these to install? if i picked them up i would get a set of gears from like FS or somthing

Pepsi50195 wrote:how difficult are these to install? if i picked them up i would get a set of gears from like FS or somthing

I am no mechanic. So to me, it's all difficult. I have a set of gears if you need them. Brand new too.

STR Pro Gears $135 local sale only.

well i hope someone will be able to answer that question, im sure Nils or Steve would know how.

PM'd u

mars wrote:PM'd u

got it

HotRodWagon wrote:

Pepsi50195 wrote:how difficult are these to install? if i picked them up i would get a set of gears from like FS or somthing

I am no mechanic. So to me, it's all difficult. I have a set of gears if you need them. Brand new too.

STR Pro Gears $135 local sale only.

$135.00 is a killer price, the FRPP gears are $137.50 EACH.

Sad to see the stuff getting sold off Chalon.