FordChip returns...
-
HotRodWagon
- Cajun Mafia
- Posts: 2515
- Joined: Sun Aug 17, 2003 7:56 pm
- Car: 01 Street Wagon/02 ZTW
- Location: Minnesota River Valley
- Contact:
Just got an email from Alberto at Fordchip...evidentally they are planning a return in the fall...but no other info yet.
-
HotRodWagon
- Cajun Mafia
- Posts: 2515
- Joined: Sun Aug 17, 2003 7:56 pm
- Car: 01 Street Wagon/02 ZTW
- Location: Minnesota River Valley
- Contact:
I emailed the thundercats to see if they were planning another session.
Alberto didn't sound to sure...I think if there was the interest they would certainly return. Put the word out there I guess.
Alberto didn't sound to sure...I think if there was the interest they would certainly return. Put the word out there I guess.
-
Louis Zerr
- and so it lives.
- Posts: 1383
- Joined: Tue Aug 12, 2003 9:24 am
- Location: Mayer, MN
CleanZX3 you gonna get that flex pipe from the guy on CF? Sounds like you will need another dyno run to check the numbers. I am intersted as to how that turns out too. Will you need to retune the chip after that install?
Nah, that guy backed out. He said his mom threw away the stock one. 
I'm just going to get the electric dump I have been planning.
The tuning cost 350 dollars. I don't know if I'm going again, maybe to get a flipchip, and a racegas/high boost program.
I'm just going to get the electric dump I have been planning.The tuning cost 350 dollars. I don't know if I'm going again, maybe to get a flipchip, and a racegas/high boost program.
07 ST S.A.P.
Dead10 wrote: CleanZX3
How did you do your setup. install your turbo kit and drive it there? how did you control the system until you got there? or did you set it up at the shop?
Dead10
I installed it, then drove there.
07 ST S.A.P.
-
Louis Zerr
- and so it lives.
- Posts: 1383
- Joined: Tue Aug 12, 2003 9:24 am
- Location: Mayer, MN
CleanZX3 wrote: I installed it, then drove there.
Wasn't there some praying and holy water involved?